Ready Access AA300 Especificaciones Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
13
Safety Information
WARNING: To avoid the risk of fire, Electric Shock or injury to persons, observe the following:
1. Before servicing or cleaning the unit, switch the power off at the mechanical switch near the unit
(Installed by an Electrician) or the electrical entry service panel/circuit breaker. (Load Center)
OSHA LOCK OUT TAG OUT procedures are to be observed to prevent power from being
switched on accidentally.
2. Any Installation and / or Electrical work must be done by QUALIFIED persons in accordance with
all applicable codes / standards and manufacturers recommendations and specifications.
3. DO NOT insert fingers and / or foreign objects into the Drive-Thru Window.
DO NOT block or tamper with the unit in any manner while it is in operation.
4. This product must not be used in Potentially Dangerous locations such as Flammable, Explosive
Chemical laden environment.
Installation Procedures
Tools required to perform the installation
Electric Drill
Metal Drill bits
?” (3mm)
¼” (6mm)
½” (13mm)
1” (25mm)
Screwdrivers Slotted and Phillips
Hacksaw
Jack / Utility Knife
Flat File Coarse
Caulking gun
¼” Nut Driver
Extension Cord
Masonry drill bit
¼” (6mm)
1” (25mm)
1½” (38mm)
Masonry Hole Saw 1” (25mm)
Channel Lock Pliers
Tape Measurer
Wire Cutter
Step Ladder
Level
Materials required for installation
Window framing, architect specified and installed in building.
(Ready Access recommended material is ?“ (3mm) x 1 ¾” (44.5mm) x 4” (102mm) hollow
aluminum tubing or glazing channel)
Electrical Tape
Wire Nuts
Caulking silicone (Color specific to the color of window)
Connectors for conduit as required
Shingle type shims – as required to level and plum the window
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comentarios a estos manuales

Sin comentarios